vendredi 6 mars 2015
Adjusting Flow Bindings
Posted on 08:06 by Immigration
d
I just received my new Flow Fuse bindings and am working on getting them set up as close as possible so I don't have to tweak too much on the slopes.
I have a bit more heel side overhang than toe side, both on the binding and on the board. I feel like I should have my boot centered over the binding first and then mess with the disks to get centered over the board.
It is a size 9 boot Ina large binding. I have 1 and 7/8 overhang on the rear over the binding, and 5/8 over the front. I have about 1 and 1/4 over the toe edge of the board and 1/2 over the heel edge.
It seems the only way to get the boot centered on the binding would be to adjust the heel cup forward, which I don't like because even with a relatively low volume boot my front ladders barely go under the ladder covers.
Any good suggestions?
Thanks!
I have a bit more heel side overhang than toe side, both on the binding and on the board. I feel like I should have my boot centered over the binding first and then mess with the disks to get centered over the board.
It is a size 9 boot Ina large binding. I have 1 and 7/8 overhang on the rear over the binding, and 5/8 over the front. I have about 1 and 1/4 over the toe edge of the board and 1/2 over the heel edge.
It seems the only way to get the boot centered on the binding would be to adjust the heel cup forward, which I don't like because even with a relatively low volume boot my front ladders barely go under the ladder covers.
Any good suggestions?
Thanks!
Adjusting Flow Bindings
Categories: Adjusting Flow Bindings
Inscription à :
Publier les commentaires (Atom)
0 commentaires:
Enregistrer un commentaire